0281010045 — Bosch MS6.2 ECU, DAF XF95
Original (stock) ECU file for the DAF XF95 — 12600 480HP, Bosch MS6.2 controller, hardware 0281010045. Unmodified factory read, usually within 3 hours after we confirm your ECU numbers.
Identification
| Vehicle | DAF XF95 |
|---|---|
| Engine | 12600 480HP |
| ECU | Bosch MS6.2 |
| Hardware number | 0281010045 |
Compatibility
The same Bosch MS6.2 with part number 0281010045 is also fitted to these vehicles / engines in our archive:
Cross references
Other software levels recorded on hardware 0281010045:
What you get
A full, unmodified read of the Bosch MS6.2 as it left the factory — the binary file produced by the original reading tool, no checksum or map changes. Use it to restore a stock calibration after a failed flash or a bad tune, or as the reference file for a tuning job. 4 reads are stored for this identification; you receive the one matching your ECU identification.
| Archive reference | Driver | Damos / A2L |
|---|---|---|
| DAF_002D | DAF_002D | — |
| DAF_777F | DAF_777F | — |
| DAF_787E | DAF_787E | — |
| DXF_797D | DXF_797D | — |
Delivery: released to your account and announced by email usually within 3 hours, within 24 hours on business days, once we confirm the read matches the numbers on this page.
Questions about this file
Is this original file compatible with my DAF XF95?
Compare the hardware number (0281010045) with the identification your tool reads from the ECU, then send us the software number you read so we confirm the exact calibration before delivery. Bosch MS6.x controllers (MAN, Scania older generations) are identified by hardware and software numbers on the label; reads are normally done in bench/BDM mode.
What exactly do I receive when I buy the Bosch MS6.2 original for €25?
An unmodified factory read of the Bosch MS6.2 (HW 0281010045) as stored in our archive — a binary file in the format produced by the original reading tool, chosen among the 4 reads listed on this page after we match your identification. No modifications, no checksum changes: it is meant to restore the ECU to its stock calibration or to serve as a reference for a tuning job.
How and when is the file delivered?
After payment we confirm the read matches the numbers on this page and release it to your account, with an email notification — usually within 3 hours, within 24 hours on business days. If your ECU reports different numbers, tell us with the order and we look for the right file before delivering anything.
Can you also tune this Bosch MS6.2 or remove EGR / AdBlue / DPF?
Yes — upload your own read through the tuning service and choose the modifications; every tuning job is quoted individually before you pay. The original on this page is useful as a backup before any modification is flashed.